Raychem QuickStat Instalační manuál stáhnout pdf (Strana 5)

QuickNet-RK Installation Instructions

• Strip 1/2" of insulation off both ends of each jumper wire.

• Slide SolderSleeve connector onto one heating wire.

• Insert jumper wire into SolderSleeve connector.

• Heat SolderSleeve connectors until solder and adhesive have

melted. (The colored solder ring will turn clear when melted.)

• Allow to cool, then repeat for second jumper wire.

• Slide two heat-shrinkable tubes onto each jumper wire.

• Slide SolderSleeve connector onto one heating wire.

• Insert jumper wire into SolderSleeve connector.

• Cut jumper wires to length allowing for 1/2" overlap on each

end as shown.

1/2"

Heating

wire

SolderSleeve

Jumper

wire

1 2 3 4 5 6 7 8

Žádné komentáře

Raychem QuickStat Instalační manuál Strana 5